Module điều khiển Motion 2 trục tốc độ cao ICP DAS I-8092F-G
Features
- Independent 2-axis motion control
- Support for hand wheel and jog functions
- 2-axis linear / 2-axis circular interpolation function
- Continuous interpolation function
- Programmable T/S-curve acceleration and deceleration
- A maximum pulse output rate of 4 Mpps for each axis
- Pulse Output Types: CW/CCW or PULSE/DIR
- 32-bit encoder counter for each axis
- Encoder Pulse Input Types: A/B Phase or Up/Down
- Programmable automatic homing for each axis
- Programmable software limits
- Expandable Remote I/O: 128 DI and 128 DO via a two-wire FRnet interface

2-Axis Linear Interpolation

2-Axis Circular Interpolation

Continuous interpolation

Introduction
The I-8092F is a 2-axis stepping/pulse-type servo motor control module that can be used on any of the ICP DAS I-8000 and PAC series controllers, and is suitable for general-purpose motion control applications. The I-8092F is equipped with one FRnet master, which allows fast remote I/O to be easily expanded. The two-wire FRnet interface can be used automatically scan its 128 DI and 128 DO channels with a scan period of 2.88 ms.
In addition to its wide speed range, this intelligent motion controller also has a variety of motion control functions built in, such as 2-axis linear interpolation, 2-axis circular interpolation, T/S-curve acceleration/deceleration, and others. A major advantage is that the majority of the I-8092F motion control functions are performed by the high-performance motion ASIC with little load on the processor. While driving the motors, the motion status, and the status of the other I/O channels on the I-8000 or PAC modules, can still be monitored.
As a result of the low CPU loading requirements of the I-8092F, one or more motion modules may be used on a single I-8000 or PAC controller. ICP DAS provides a wide range of functions and examples that can be used to reduce the need for programming by users, making it a highly cost-effective solution for motion control application developers.
Specifications
| Number of Axes | 2 |
| Maximum Pulse Output Rate | 4 MHz |
| Command Type | Pulse Command |
| Resolution | 32-bit |
| Pulse Output Mode | CW/CCW, PULSE/DIR |
| Operation Mode | Semi-closed Loop |
| Linear Interpolation | 2 axes |
| Circular Interpolation | 2 axes |
| Speed Curve Profile | T/S-curve |
| Motion Relative I/O | Home, LMT+/-, NHOME, EMG, INP, ALM, SVON |
| Synchronous Action | – |
| Ring Counter Mode | 32-bit |
| Position Control Mode | Incremental mode |
| Position Compare Trigger | – |
| Encoder Interface | A/B pulse, Up/Down |
| Encoder Counter | 32-bit |
| Encoder Rate | 4 MHz |
| Digital Input Channels | Expandable: 128 DI |
| Digital Output Channels | Expandable: 128 DO |
| I/O Isolation (with DN-8237) | 2500 Vrms optical isolation |
| Connector | 37-pin D-Sub |
| Power Consumption | +5 V @ 500 mA |
| Environmental | |
| Operating Temperature | -20 ~ +75°C |
| Storage Temperature | -30 ~ +85°C |
| Ambient Relative Humidity | 5 ~ 90% RH, non-condensing |
Ordering information
| I-8092F-G | High-speed 2-axis Motion Control Module with FRnet Master |
