Bộ chuyển đổi Hart sang quang singel mode SC ICP DAS HRT-227CS
The HRT-227CS is a HART to Fiber converter paired used to extend HART communication distance via single mode fiber optic transmission medium. In order to solve the problem between HART and fiber transmission medium, HRT-227CS is specially designed for converting the HART signal to fiber optic cables. Built-in a HART 250 Ω loop resistor adjustable by dip switch. Therefore, users can make data collection and processing of HART network easier and quicker by applying HRT-227CS. In addition, we also provide the free HC_Tool utility for module configuration easily.

Applications
- Current Measuring
- Petrochemical Industry Application
- Environment Monitoring
- Tunnel Monitoring
- Monitor system
- Building Monitoring
Features
- Support HART Short/Long frame
- Support HART Burst mode
- Support point-to-point or multi-drop HART mode
- Support connecting up to 15 HART slave devices
- Allow two HART masters
- Provide HC_Tool utility for module configuration
- Support firmware update via ComPort
- Fiber broken line detection
- Fiber Type: SC ; Single mode ; 100 Base-FX
- Fiber max. transmission distance up to 30 km
- 4KV ESD Protection
- Built-in Watchdog
- Selectable 250Ω loop resistor
- The HART port with the same Group ID can communicate with each other
Hardware Specifications
| HART Interface | |
| Channel | 1 |
| Connector | 2-pin screwed terminal block (HART+, HART-) |
| Loop Resistor | Selectable 250 Ω loop resistor |
| HART Data | Only Digital Data |
| Isolation | UL1577 Spec. |
| Fiber Interface | |
| Type | SC Duplex type ; Single mode ; 100 Base-FX |
| Wave Length (nm) | 1310 |
| Fiber Cable (μm) | 8.3/125, 8.7/125, 9/125 or 10/125 |
| Transmission Distance (km) | 30 (indicative only) |
| Min. TX Output (dBm) | -15 |
| Max. TX Output (dBm) | -8 |
| Max. RX Sensitivity (dBm) | -34 |
| Max. RX Overload (dBm) | -5 |
| Budget (dBm) | 19 |
| UART Interface | |
| COM1 | RS-232 (TXD / RXD / GND) for configuration (1200, O, 8 ,1) |
| LED | |
| Round LED | PWR, FB_Ack, FB_Err, HT_Err, HT_Tx and HT_Rx |
| Power | |
| Power supply | Unregulated +10 ~ +30 VDC |
| Protection | Power reverse polarity protection, Over-voltage brown-out protection |
| Power Consumption | 3W |
| Mechanism | |
| Installation | DIN-Rail |
| Dimensions | 33.0 mm x 126 mm x 101 mm (W x L x H) |
| Environment | |
| Operating Temp. | -25 °C ~ +75 °C (-13 to 167ºF) |
| Storage Temp. | -30 °C ~ +80 °C (-22 to 176ºF) |
| Humidity | 10% ~ 90% RH, non-condensing |
Ordering Information
|
HRT-227CS
|
HART to Single Mode Fiber Converter (RoHS) |
